Saturday, September 19, 2026

Suspension Overhaul.

209,267 miles.

The right front wheel bearing has been howling at highway speeds for most of the year and I finally got around to addressing it. Midas also recommended replacing one of the CV axles, lower control arms, and the outer tie rods, and since all these parts connect I decided to do them all, both sides, and throw in the struts and rear shocks for good measure. Their quote would have been around $5000, but I was able to purchase all the parts from Rock Auto for around $1200 and knock it out over a weekend thanks to a neighbor's floor jack and stands and another neighbors socket kit and a loaner torque wrench from Autozone.

In total I replaced:
- lower control arms (MEVOTECH GK80399 and GK80400)
- front struts (MONROE 171593 and 171594)
- CV half axles (TRAKMOTIVE FD8142 and FD8095)
- loaded knuckles with new wheel bearings (DORMAN 698404 and 698405)
- outer tie rod ends (MEVOTECH)
- anti sway bar links and bushings (DELPHI TD4161W)
- rear shocks (MONROE 37318)
- brake pads and rotors (POWER STOP CRK4581)
- changed the transaxle fluid (VALVOLINE 822405)
- added a camber bolt to the passenger side strut mount (MOOG K90473)

I did not replace the inner tie rod ends because they looked tricky to remove and I didn't have the special tool, and I also did not replace the axle shaft seals for the same reason.

You'll never believe that after 200k miles with zero brake service the original pads had about half the pad left and would have gone another 100k miles with no problems.

After replacing all these parts the alignment was completely out but I took it down to Midas and they dialed it in nicely.









No comments:

Post a Comment